To make a battery for heating a garage or a house in the country, you will need four gas cylinders from under propane. Naturally, they should be empty. If you purchase a cylinder on a metal receiver, make sure there is no propane in it.
Before proceeding with the manufacture of the battery, it is necessary to unscrew the valve and drain the remaining gasoline, and before cutting the grinder, be sure to fill the cylinder to the top with water. Without water, it is not recommended to cut the cylinder, even if it is empty.
First of all, it is necessary to cut off the upper part of all four gas cylinders. Two will need to cut off the bottom as well. In fact, you should get a piece of hollow pipe. Also, then two doors will need to be made of two cut covers.
The main stages of work
After the doors were cut, it is necessary to make locking mechanisms. To do this, you can use segments of the profile pipe 15x15 mm. Also, long bolts with nuts and washers are required to secure the mechanism itself to the door.
At the next stage of work, gas cylinders are welded together in length of two pieces. Additionally, an ash pan is cut out. Also, the cylinders are connected to each other using a pipe so that the smoke from the lower cylinders passes into the upper ones, and from there it already enters the chimney.
For more information on how to make a large battery of gas cylinders for heating a garage or a country house, see the video on our website. Thanks for your attention!
