ROCKING-CHAIR FOR THE MOBILE PHONE

Send

Hello!

Here is such a homemade product. Rocking-chair for the mobile phone.

A second use case is possible - as a card holder.

The execution is very simple.

Material - a furniture board, or plywood, or just a piece of board. PVA. A pair of clamps.

1 The sides of the chair are quarters of a circle, radius 96 mm. Cut with a jigsaw or a hacksaw and trimmed with a block of sandpaper.

2 The back of the chair is a 100 by 55 rectangle.

3 The seat of the chair is again a 50 by 55 rectangle. (55 mm is the width of a small nokia. If you need to make a smartphone, you need 65)

4 Cut from the board, grind, mill.

5 Glue the back and seat.

6 Optional - after gluing, it would be nice to align the joint from the bottom between the seat and the back with sandpaper - so that there is no unpleasant step-roughness.

7 Then we glue the sides of the chair.

8 Optional - varnish

9 And also optionally - drill a hole for the charging connector so that the phone can be charged while lying in the chair. In the photographed copy, there is such a hole, it is in the seat under the phone.