ROSE BEAD

Send

All girls love flowers. Unfortunately, living flowers quickly fade. They are replaced by artificial ones. But even they cannot keep their appearance perfect for long. And it’s not customary to give artificial flowers - this is a bad taste. But now there is a solution - handmade roses from beads. You can give them, keep them (in the form of a bouquet) or make an ornament, headed by your rose.
So, in order to make roses from beads you will need:
- scissors
- fishing line, wire (thin, 0.3 mm), can be colored.
- green beads (0.4 mm)
- beads of any colors (those that will be responsible for the color of the rose, I took a lot of different ones)
Floristic tape (optional)

Let's start with the formation of the petals, as this is the most difficult. If you succeed, then you can make the rest of the rose. Take the fishing line (wire) and, measuring about 0.6 m from it, cut it off, and then bend it in half. Pass one bead of any color on it (the one that your flower will be).

Put another 2 beads on one end and thread the other end of the wire through them.

Pull both ends. You should have the following:

Continue to type beads using similar technique, forming rows. To begin with, 1 bead, then 2, after 4 and so on until you make a row of 16 beads.

Now put another 10 beads on one end.

After that, pass the end of the side with the beads through the lowest bead - this will be one side of the edging.

Tighten. The result is approximately the following:

Do the same on the other side.

And fasten the petal.

You get a finished rose petal. Such parts need to be made 4 pieces. After that, by analogy, make 5 small petals. To do this, dial the rows in 1, 2, 4, 6, 8, 10, 12 and 14 rows, and the edging is made of 9 beads.

Give the petals a shape.

Now start shaping the bud. Start with 5 small petals - this is the middle.

Fasten the petals with each other with wire. After the small parts are over, shape the bud with the large ones.

Now you need to make leaves. They are performed by the same technique. Take a wire 30 cm long, bend in half, put on 1 bead, then form a row of 2, 3, 4, 3, 2 and 1 beads in the same way as the petals did. Leaves need 6 pieces.

Similarly, perform larger leaves in the amount of 3-4 pieces. Do the rows: 1, 2, 3, 4, 5, 6, 5, 4, 3, 2, 1 beads.

Attach small leaflets to the bottom of the bud.

And the leaves are larger - to the stem formed from the wire.

Ultimately, you get a finished rose. You can wrap the resulting stalk with floral tape or use colored wire. This will help hold the bud.

In order for the bud to hold its shape better, you can pass a wire through it, or rather, wrap it slightly this part of the flower. Instead of a stem made of wire, you can use a pen. Then, while forming the bud, wind and fasten the entire “structure” onto the future stem. Such roses are made very quickly, especially if a hand is already full. You can make it literally in 15 minutes, and the sea will be joyful. No one can resist a bouquet of roses, made by yourself.

Send