SATIN RIBBON HOOP WITH CHRYSANTHEMUM COMPOSITION

Send

A hoop with flowers will decorate the girl’s hairstyle at school, garden, for a walk or even at school. A composition of 2 larger and smaller chrysanthemums consists.
To make jewelry you need:
- red satin ribbon width 1 and 2.5 cm;
- the basis of felt;
- blank hoop;
- green ribbon for leaflets;
- glue;
- lighter.
For a large chrysanthemum, we use a ribbon whose width is 2.5 cm. It should be cut into pieces of 5 cm.

We fold one piece of tape along in half and cut off the sharp corner.

Next, we fix the edge of the tape over the fire, do not touch the sharp edge, and on the other hand we add the corners in the middle, hold with tweezers and fix the edge over the fire.

One sharp petal is ready. By the same principle we will make all the other petals.

For a large flower you will need 30 petals, for a small one - 20.
For small chrysanthemums, we use 3 cm segments of a red ribbon. Assembling a flower For a large flower, we use a felt base with a diameter of 4 cm.

Distribute 12 petals along the edge of the circle. Next, gradually fill the base with petals as densely as possible, then the flower will turn out more magnificent.

One flower can be attached to a bandage and used for the smallest fashionistas.

We collect a small flower on the basis of a diameter of 3 cm.

This is the back side of each flower.

On the front side, the flowers form a beautiful composition.

Glue three large leaves to the base of a large color, and three small leaves to the base of a small color.

We wrap the hoop with a ribbon 1 cm wide. Glue the flowers on the hoop so that the big one is closer to the center and the leaves are directed in different directions.