NEEDLE BED

Send

It seems very simple to sew a needle bar in the form of a square pad. But the needlewoman always wants something unusual and this is even necessary for creative inspiration. More complex needle cases include sewing soft toys in the form of hedgehogs and other animals. But if there is absolutely no time for sewing toys, but urgently needed, then you can sew a needle bar in a matter of minutes. In this workshop, we sew a round needle bar that resembles a flower.
For sewing we need:
• 100% cotton;
• threads;
• a needle for tailoring and a large needle;
• synthetic winterizer;
• scissors;
• pencil;
• beads for decoration;
• glue gun.
We will also drag the pillow in threads, dividing it into sectors that mimic the petals of a flower. You can take some other material for this purpose, for example, a waxed cord, tape, etc. The main thing is that this material is very durable and not torn.

Fold the fabric in two layers with the face inward. Use a pencil to circle a round object, the diameter of which coincides with the desired size of the pillow. In the master class, the diameter is 10 cm. We cut the workpiece with scissors, leaving allowances.

We connect the two parts with a stitch seam, so that it is convenient to stitch further.

We completely sew the two parts with a seam, making the same stitches and tightening them tightly. You can sew on a typewriter.

We pull the thread, which swept away the details. We make an incision of 3-4 cm on only one side of the fabric in the center.

We turn the workpiece out, straighten the edges and start stuffing it evenly with a synthetic winterizer. We begin to do this by laying pieces of padding polyester from the edge and closer to the center until we push the pillow back to back.

We sew the incision when we finished stuffing the pillow. Perhaps it will turn out not quite ideal - it depends on the quality of the fabric. But we will hide all the defects of the seam with threads and decorate with beads.

Take a large needle, thread a very long thread, which must be folded in half. At the end of the thread we tie a knot. We begin to divide the pillow into sectors. To do this, insert the needle in the center and withdraw it from the back, then again thread it from top to bottom and tighten it well. For one such strip we make three circles and continue, going to the opposite side. First, close the seam with threads, and then move on. We make sure that the needle constantly falls into the same hole both from above and from below.
If the thread is over and you have not yet tightened the required number of sectors, just tighten the knot right next to the fabric and cut the thread. Thread the thread into the needle again and continue to tighten.
You can do as many sectors as you want. It all depends on the diameter of the pads.

The central part, where the bundle of threads is located, is decorated with a large bead both in the upper part and in the lower one. So we hid the wound bundle.