LILAC DRESSING

Send

A convenient bandage, with a beautiful flower, will help to decorate your hair on weekdays and on a holiday for a very small beauty. The color of the dressing combines shades of purple satin with a lilac color, so the flower looks original and unusual.
For creativity you will need:
- satin purple ribbon 2.5 cm wide;
- satin lilac ribbon 4 cm wide;
- white satin ribbon 5 cm wide;
- burner, glass, ruler, tweezers;
- hot glue (gun with rods);
- a beautiful center with a rhinestone for a flower;
- white lace for dressing;
- mesh (tulle) for decoration of white color, better than average density.
Getting started with creativity. First of all, we cut a narrow tape into pieces of about 15 pieces in length 7 cm. We make sharp petals for a frill of a flower. We bend a piece of tape along half and cut the angle to 45 degrees. Next, bend at the base two symmetrical clamps on the right and left.

We glue the resulting petals on a circle of satin with a diameter of 4 cm (cut it in advance and be sure to burn it with a lighter). Glue the petals in three to four layers evenly and symmetrically. You get such a magnificent base for the flower, as in the photo.

We form the petals of the main flower. To do this, cut the white ribbon into squares 5 by 5 cm, a total of 9 blanks. We form a sharp petal from each blank. Fold the square diagonally and bend again - we get a triangle.

Cut the lilac ribbon into 16 squares measuring 4 by 4 cm. Of the eight, we form inserts for white petals. To do this, bend the workpiece diagonally and turn the corners to the center of the base.

We bend the lilac blank in half and put it into a white triangle. Try to keep the center of one layer aligned with the center of the other.

Solder the base under the ruler with a hot burner. Try to get one straight line. Sew eight petals with a simple thread into one flower.

From the remaining eight lilac blanks, we make simple petals as above, only without a white layer. Glue each petal into the flower slots, as in the photo.

Glue the flower on the fluffy base of purple petals. In the middle of the flower we select a beautiful rhinestone to match the color. On this flower, the middle of the festive hairpin, it is very beautiful, convenient and easy to glue.

Pre-measure the desired size on the head, then solder the edges with a burner, holding with a ruler. Turn the work over and glue the folds of tulle. The size of the grid rectangle is approximately 10 cm wide and 7 in length. Squeeze more glue on top and apply a bandage of white lace, press lightly.

After 10 minutes, the work will dry and you can decorate the baby's head. If the length of the grid does not fit the baby - it can always be corrected, removed from the head and cut with scissors to the desired size. Try to round the corners on the grid.